How to apply the wax: The skin must be clean and dry. The hair length should not be less than 2 mm or more than 5 mm, if it was, cut it before hair removal. If the temperature is below 20 ºC, heat the click pen between your hands until it is easy to extract the wax. For a first use, remove the cap and press the click pen mechanism slowly until the wax is close to the applicator hole. If necessary, press the mechanism again until you get the necessary amount of wax. For successive uses, press the mechanism approximately four times waiting for the product to come out. If the mechanism offers resistance by pressing, wait for the wax to come out, if necessary, press again. Apply very thin and uniform wax layers on the skin in the direction of hair growth with the applicator.
How to remove the wax: Place a strip over the wax and smooth it down firmly in the direction of hair growth. Leave at least 1 cm of the strip free of wax so that you can pull it easily. Immediately after applying the strip, keep the skin taut with one hand, and with the other hand pull the strip quickly and firmly against the direction of hair growth, keeping the strip parallel and as close to the skin as possible.
Upper lip: wax each side of the lip separately. Apply the wax from the centre of the upper lip to the corner of the mouth in the direction of hair growth. Apply the strip, keeping the skin taut with one hand, and with the other hand pull the strip quickly and firmly against the direction of hair growth. Repeat on the other side of the lip.
Eyebrows: Apply the wax from the area closest to the nose to the end of the eyebrow, following the shape of the brow. Apply the strip, keeping the skin taut one hand, and with the other hand pull the strip quickly and firmly towards the nose. If the shape of the brow is very curved, you should do the waxing in stages. For below the brow, and because the eyelid is very delicate, it is especially important to keep the skin taut when pulling the strip. Repeat on the other eyebrow.
If the layer of wax applied is too thick, or is applied to the wrong area, remove with cotton moistened with Geomar Almond oil, wash with soap, and then dry the area thoroughly before reapplying the wax.
Do not depilate the same area more than twice during the same depilation session to avoid skin irritation.
How to remove the wax residue: apply a post-waxing finishing wipe or use a cotton pad soaked in GEOMAR Almond Body Oil, 100% pure. After each use, remove the remaining wax from the applicator with one of the extra strips, and close well to keep the product in perfect condition.